12 063
правки
SC16IS752/en: различия между версиями
Нет описания правки
(Новая страница: «sc16is7x2 driver exports 8 GPIOs into the standard Linux sysfs-interface under numbers 120-127.») |
|||
| (не показана 1 промежуточная версия этого же участника) | |||
| Строка 1: | Строка 1: | ||
<languages/> | <languages/> | ||
'''SC16IS752''' is a chip that controls serial ports in some versions of the Wiren Board. | '''SC16IS752''' is a chip that controls serial ports in some versions of the Wiren Board controllers. | ||
| Строка 45: | Строка 45: | ||
===UART0=== | ===UART0=== | ||
The device in Linux: <b>/dev/ttyNSC0</b>. TX/RX port lines are output to [[ | The device in Linux: <b>/dev/ttyNSC0</b>. TX/RX port lines are output to [[UEXT UEXT2|UEXT UEXT2]]. A half-duplex [[RS-485|RS-485]]-transceiver(if any) is connected to them in parallel. | ||
The direction of operation of the transceiver is set by the chip using the RTS signal automatically, the hardware flow control must be disabled. In future versions of the driver, RS-485 mode may need to be activated from the userspace. | The direction of operation of the transceiver is set by the chip using the RTS signal automatically, the hardware flow control must be disabled. In future versions of the driver, RS-485 mode may need to be activated from the userspace. | ||