Translations:WB-MSx Consumer IR Manual/20/en: различия между версиями

=== Recording the signal to the RAM from the remote control ===

To write a signal (only one) from the remote control to the RAM without putting it in the ROM - write 1 in the flag register at <code>5001</code>. Further actions occur in the same way as described above to record the signal in ROM. After the recording is stopped in the storage registers at <code>2000</code>, the signal will be stored as a sequence of numbers. You can edit this sequence as described above. Note: the contents of these storage registers are not stored when the device is powered off!

To play the signal from memory, write 1 to the flag register at <code>5002</code>. The signal recorded in the storage registers starting with <code>2000</code>will be played. In the absence of the marker of the end of the command will return an error. While the signal is playing, the flag register at <code>5002</code> will be set to 1 and then set to 0. While the signal is being played, no other operations with the IR transceiver via Modbus will be available.