Перейти к содержанию

Навигация

WB-MCM8 Modbus Count Inputs/en: различия между версиями

Нет описания правки
(Новая страница: «== General principle of operation == === Indication === 300px|thumb|right| WB-MCM8 module indication {{Wbincludes:Module Indication}} * 1–7 — status of inputs: lit — input is closed. There is no indicator for the eighth entry. === Inputs === 300px|thumb|right|DI digital inputs (first version, ~4.5V inputs) The WB-MCM8 inputs work on the principle of "dry contact" - shorting the input to ground ignd ca...»)
 
(не показаны 3 промежуточные версии 2 участников)
Строка 80: Строка 80:
When a pulse arrives at the WB-MCM8 input, the corresponding LED lights up, the value of the input state changes, and the value of the counter of operations of this input increases. The values ​​of all operation counters are recorded in the non-volatile memory of the device. The number of counters is 32 bits.
When a pulse arrives at the WB-MCM8 input, the corresponding LED lights up, the value of the input state changes, and the value of the counter of operations of this input increases. The values ​​of all operation counters are recorded in the non-volatile memory of the device. The number of counters is 32 bits.


<div lang="ru" dir="ltr" class="mw-content-ltr">
For each input, the debounce time parameter can be changed. Starting with firmware version 1.2.0, it is possible to measure the pulse frequency at the input. The maximum measured frequency is achieved when the debounce time parameter is set to 0 and depends on the revision of the device - from ~1.2 to ~3.2 kHz.
Для каждого входа можно изменить параметр времени антидребезга. Начиная с версии прошивки 1.2.0, доступно измерение частоты импульсов на входе. Максимальная измеряемая частота достигается при выставлении параметра времени антидребезга в 0 и зависит от ревизии устройства — от ~1.2 до ~3.2 кГц.
</div>


<div lang="ru" dir="ltr" class="mw-content-ltr">
=== Recognition of types of clicks ===
=== Распознавание типов нажатий ===
{{Anchors|press-events}}
{{Anchor|press-events}}
{{note|note|Recognition of types of clicks appeared in firmware 1.3.2.}}
{{note|note|Распознавание типов нажатий появилось в прошивке 1.3.2.}}
In this mode, the frequency of the input signal is not measured.
В этом режиме измерения частоты входного сигнала не происходит.
{{Wbincludes:Inputs Press Events|no_outputs=true}}
{{Wbincludes:Inputs Press Events|no_outputs=true}}
</div>


<div lang="ru" dir="ltr" class="mw-content-ltr">
<div lang="ru" dir="ltr" class="mw-content-ltr">
Строка 173: Строка 169:
</div>
</div>


<div lang="ru" dir="ltr" class="mw-content-ltr">
==Обновление прошивки и сброс настроек==
==Обновление прошивки и сброс настроек==
{{Wbincludes:Firmware update|changelog=WB-MCM8: Changelog}}
{{Modbus Device Firmware Update
</div>
| lose=true
| old=true
|changelog=WB-MCM8: Changelog}}


<div lang="ru" dir="ltr" class="mw-content-ltr">
<div lang="ru" dir="ltr" class="mw-content-ltr">
translator, wb_editors
4251

правка