12 063
правки
WB-MR6F Modbus Relay Module/en: различия между версиями
Новая страница: «A button connected to input 0 allows you to turn off all the relays included in the module with a single press. Pressing again will turn on all the relays that we…»
(Новая страница: «The Safety Timer slider allows you to set the shutdown time (in seconds) of all outputs when there is no communication with the Wiren Board (0 – the safety time…») |
(Новая страница: «A button connected to input 0 allows you to turn off all the relays included in the module with a single press. Pressing again will turn on all the relays that we…») |
||
| Строка 236: | Строка 236: | ||
The Safety Timer slider allows you to set the shutdown time (in seconds) of all outputs when there is no communication with the Wiren Board (0 – the safety timer is disabled). When communication with the controller is resumed, the switched-off relays will remain switched off. The slider is easy to control with the arrow keys, previously focusing on it with the mouse: moving the slider with the mouse does not provide sufficient accuracy. The safety timer allows stopping technological processes in case the control over the module is lost (for example, the RS-485 cable is broken). | The Safety Timer slider allows you to set the shutdown time (in seconds) of all outputs when there is no communication with the Wiren Board (0 – the safety timer is disabled). When communication with the controller is resumed, the switched-off relays will remain switched off. The slider is easy to control with the arrow keys, previously focusing on it with the mouse: moving the slider with the mouse does not provide sufficient accuracy. The safety timer allows stopping technological processes in case the control over the module is lost (for example, the RS-485 cable is broken). | ||
A button connected to input 0 allows you to turn off all the relays included in the module with a single press. Pressing again will turn on all the relays that were switched on initially. The status of the relay is stored in memory, so if you press the button again after a power failure, the restoration of the relay will not happen. The ability to restore relay status after power supply interruption as described in section [[#Relay operation mode in case of power failure| Relay operation mode in case of power failure]]. | |||
== Режим работы реле в случае отключении питания == | == Режим работы реле в случае отключении питания == | ||