12 063
правки
WB-MR6F Modbus Relay Module/en: различия между версиями
WB-MR6F Modbus Relay Module/en (просмотреть исходный код)
Версия 18:23, 27 ноября 2019
, 4 года назадНет описания правки
(Новая страница: «== Known faults and bugs ==») |
|||
| (не показаны 2 промежуточные версии этого же участника) | |||
| Строка 27: | Строка 27: | ||
Each input controls the state of the corresponding relay. | Each input controls the state of the corresponding relay. | ||
The inputs have two modes of operation: trigger mode (for control with buttons) and repeat mode (for control with switches). In the trigger mode, to change the state of the relay, it is enough to close and open the input once. The change of state occurs on the rising edge (that is, when the circuit). In the repeat mode, the relay state is determined by the input state: the input is closed — the relay is on, open — off. Details about the mode switching written in [[ Modbus Management | The inputs have two modes of operation: trigger mode (for control with buttons) and repeat mode (for control with switches). In the trigger mode, to change the state of the relay, it is enough to close and open the input once. The change of state occurs on the rising edge (that is, when the circuit). In the repeat mode, the relay state is determined by the input state: the input is closed — the relay is on, open — off. Details about the mode switching written in [[Relay Module Modbus Management/en|Relay Module Modbus Management]]. | ||
| Строка 249: | Строка 249: | ||
== Device firmware update == | == Device firmware update == | ||
Starting with the new firmware versions of the device, the firmware update functionality (firmware) via the Modbus Protocol is supported. This makes it possible to extend the functionality of the devices and eliminate errors in the firmware directly at the installation site. Read more about flashing devices described in the article [[WB-MCU-Flasher|Download firmware to Wiren Board devices]]. A list of firmware versions that support the update, as well as devices for which this feature is implemented, can be found in [[Firmware_Changelog | Starting with the new firmware versions of the device, the firmware update functionality (firmware) via the Modbus Protocol is supported. This makes it possible to extend the functionality of the devices and eliminate errors in the firmware directly at the installation site. Read more about flashing devices described in the article [[WB-MCU-Flasher|Download firmware to Wiren Board devices]]. A list of firmware versions that support the update, as well as devices for which this feature is implemented, can be found in [[Firmware_Changelog| Firmware Changelog]]. | ||
== Known faults and bugs == | == Known faults and bugs == | ||
[[WB-MR:_Errata | | [[WB-MR:_Errata/en |List of known faults]] | ||