WB-MR: Errata/en: различия между версиями
(Новая страница: «====Description====») |
(Новая страница: «After power supply and switching the relay module on, its inputs are not read, in the registers of discrete inputs, the values are 0 even if the input is supplied…») |
||
Строка 8: | Строка 8: | ||
====Description==== | ====Description==== | ||
After power supply and switching the relay module on, its inputs are not read, in the registers of discrete inputs, the values are 0 even if the input is supplied with 1. The value becomes relevant the first time you switch the input. | |||
====Запланированное исправление==== | ====Запланированное исправление==== |
Версия 10:56, 16 июля 2019
Digital input registers contain 0 instead of the actual signal after switching on
Affected devices
WB-MR and WB-MWAC with firmware v. 1.9.x 1.10.x
Description
After power supply and switching the relay module on, its inputs are not read, in the registers of discrete inputs, the values are 0 even if the input is supplied with 1. The value becomes relevant the first time you switch the input.
Запланированное исправление
Исправлено в 1.11.1 При включении устройства состояние его входов попадает в регистры дискретных входов При этом выход никак не реагирует и либо отключен, либо загружает состояние перед выключением из памяти если эта функция включена в регистре 6. Маппинг матрица не обрабатывает вход. Только если настроен режим работы входа - 5 (датчки протечки с повторением через 20 минут) происходит обработка входа как события и реакция на него через маппинг матрицу. Все реакции выполняются после дальнейших изменений входов.