12 063
правки
WB-MSW v.3 Modbus Sensor/en: различия между версиями
Новая страница: «==== How to open the sensor housing ==== {| border="1" cellpadding="2" cellspacing="1" | 450px|thumb|center| || File:WB-MSW3-OPEN_2…»
(Новая страница: «File:Installation_WB5_+wb-msw2.png|650px|thumb|center|Sample installation and connection of WB-MSW v.3 module. Screw clamps are located on the back side of the…») |
(Новая страница: «==== How to open the sensor housing ==== {| border="1" cellpadding="2" cellspacing="1" | 450px|thumb|center| || File:WB-MSW3-OPEN_2…») |
||
| Строка 209: | Строка 209: | ||
[[File:Installation_WB5_+wb-msw2.png|650px|thumb|center|Sample installation and connection of WB-MSW v.3 module. Screw clamps are located on the back side of the module in a special recess (see photo)]] | [[File:Installation_WB5_+wb-msw2.png|650px|thumb|center|Sample installation and connection of WB-MSW v.3 module. Screw clamps are located on the back side of the module in a special recess (see photo)]] | ||
==== | ==== How to open the sensor housing ==== | ||
{| border="1" cellpadding="2" cellspacing="1" | {| border="1" cellpadding="2" cellspacing="1" | ||
| [[File:WB-MSW3-OPEN_1_.png|450px|thumb|center|]] || | | [[File:WB-MSW3-OPEN_1_.png|450px|thumb|center|]] || [[File:WB-MSW3-OPEN_2.png|450px|thumb|center|]] || [[File:WB-MSW3-OPEN_3.png|450px|thumb|center|]] | ||
|- | |- | ||
| | | Locate the latch tab on the underside of the sensor housing.||Push the screwdriver against the tab perpendicular to the side of the sensor housing until it stops.|| Lift the top cover of the sensor. | ||
|- | |- | ||
|} | |} | ||
== | == Th and VOC modules == | ||
Temperature/humidity (TH) and VOC measurement are done on separate modules. Modules are installed on the arrow in the connectors. '''For more accurate measurement, the TH module must be installed in the upper left connector.''' Otherwise it is heated by the CO2 sensor and overestimates the reading by 1-2 degrees. | |||
== Индикация == | == Индикация == | ||