WBE-DI-DR-3/en: различия между версиями
Fizikdaos (обсуждение | вклад) (Новая страница: «State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms.») |
Fizikdaos (обсуждение | вклад) (Новая страница: «Installed in slot MOD-1 or MOD-2 controller Wiren Board 5.») |
||
| Строка 11: | Строка 11: | ||
State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms. | State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms. | ||
Installed in slot MOD-1 or MOD-2 controller [[Special: MyLanguage / Wiren Board 5 | Wiren Board 5]]. | |||
Три канала. | Три канала. | ||
Версия 17:12, 14 января 2016
Extension Module, 3 digital inputs
The module for connection of sensors, counters to the outputs of the type "Dry contact" or "open collector".
State of logic low: input in air.
State of logical high: input is connected to ground (GND) of the controller. It allowed to connect either directly or through the resistance less than 300 ohms.
Installed in slot MOD-1 or MOD-2 controller Wiren Board 5.
Три канала.
Распиновка:
| Клемма | Функция |
|---|---|
| O1 | Вход 1 |
| O2 | Вход 2 |
| O3 | Вход 3 |
GPIO
При установке в MOD-1
| Вход | GPIO |
|---|---|
| O1 | 85 |
| O2 | 76 |
| O3 | 91 |
При установке в MOD-2
| Вход | GPIO |
|---|---|
| O1 | 22 |
| O2 | 23 |
| O3 | 83 |