WBE2-AO-10V-2 Analog Outputs 0-10V Extension Module/en: различия между версиями
(Новая страница: «== Pinout ==») |
(Новая страница: «The signals of the converter are output to the O1-O3 terminals of the extension module.») |
||
Строка 13: | Строка 13: | ||
== Pinout == | == Pinout == | ||
The signals of the converter are output to the O1-O3 terminals of the extension module. | |||
Распиновка: | Распиновка: |
Версия 12:06, 27 июня 2019
Dual-channel extension module DAC (0 — 10 В) WBE2-AO-10V-2
Hardware
The module is built on the MCP4728 digital-to-analog converter and supports two output channels with a voltage from 0 to 10 V. In version 2.2, the output current is increased to 10 mA. The module can withstand short-term (a few seconds) output short-circuit.
Pinout
The signals of the converter are output to the O1-O3 terminals of the extension module.
Распиновка:
Клемма | Функция |
---|---|
O1 | MOD1_O1 (MOD2_O1) |
O2 | MOD1_O2 (MOD2_O2) |
O3 | GND |
Конфигурирование
Настройка осуществляется в web-интерфейсе. Раздел Configs => Hardware Modules Configuration. Далее в Internal slot 1 или в Internal slot 2 выбрать "WBE2-AO-10V-2: Dual channel analog voltage output (0-10V) module" и нажать Save.
Устройство определяется сразу же, перезагрузка не требуется.
Работа
В web-интерфейсе каналы модуля появляются в разделе Analog Outputs и называются MOD1_O1 и MOD1_O2 для модуля, установленного в первый разъем, и MOD2_O1 и MOD2_O2 для модуля, установленного во второй разъем. Значение напряжения (в милливольтах) публикуется в mqtt-топиках "/devices/wb-dac/controls/".