WBE2-AO-10V-2 Analog Outputs 0-10V Extension Module/en: различия между версиями
(Новая страница: «Configuration is set in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 or in Internal slot 2, select "WBE2-AO-10V…») |
(Новая страница: «The device is detected immediately, no reboot is required.») |
||
Строка 36: | Строка 36: | ||
The device is detected immediately, no reboot is required. | |||
== Работа == | == Работа == |
Версия 12:07, 27 июня 2019
Dual-channel extension module DAC (0 — 10 В) WBE2-AO-10V-2
Hardware
The module is built on the MCP4728 digital-to-analog converter and supports two output channels with a voltage from 0 to 10 V. In version 2.2, the output current is increased to 10 mA. The module can withstand short-term (a few seconds) output short-circuit.
Pinout
The signals of the converter are output to the O1-O3 terminals of the extension module.
Pinout:
Terminal | Function |
---|---|
O1 | MOD1_O1 (MOD2_O1) |
O2 | MOD1_O2 (MOD2_O2) |
O3 | GND |
Configuration
Configuration is set in the web interface. Section Configs => Hardware Modules Configuration. Next, in Internal slot 1 or in Internal slot 2, select "WBE2-AO-10V-2: Dual channel analog voltage output (0-10V) module" and click Save.
The device is detected immediately, no reboot is required.
Работа
В web-интерфейсе каналы модуля появляются в разделе Analog Outputs и называются MOD1_O1 и MOD1_O2 для модуля, установленного в первый разъем, и MOD2_O1 и MOD2_O2 для модуля, установленного во второй разъем. Значение напряжения (в милливольтах) публикуется в mqtt-топиках "/devices/wb-dac/controls/".