12 063
правки
(Новая страница: «Delivery of fixed Wiren Board Smart Home is possible.») |
(Новая страница: «thumb|500px| C5 capacitor in WB SH rev. 3.5 (0350006)») |
||
(не показано 26 промежуточных версий этого же участника) | |||
Строка 82: | Строка 82: | ||
''' | '''Reason''' | ||
The wrong value of the crystal oscillator. | |||
== 0350004: | == 0350004: Insufficient peak current (2) == | ||
[[File:WB3.5mount top C11.jpg|thumb|500px| | [[File:WB3.5mount top C11.jpg|thumb|500px|C11 capacitor placement in WB SH rev. 3.5 (0350004)]] | ||
''' | '''Revision''': | ||
3.5, S/N | 3.5, S/N before 230 | ||
''' | '''Description''' | ||
In devices shipped before 20.06.2014 (serial numbers less than 230), the power supply circuit incorrectly limits the output current. | |||
''' | '''Symptoms''' | ||
If GSM is active and the signal level is poor, it can be observed under certain conditions: | |||
* | * reboot the Board | ||
* | * disable and reconnect the Wi-Fi module | ||
* | * Ethernet shutdown | ||
''' | '''How to fix''' | ||
Unsoldering capacitor C11 fixes the problem. See diagram. | |||
== 0350005: | == 0350005: Leads from GSM on prtctrl line == | ||
''' | '''Revision''': | ||
3.5 | 3.5 | ||
''' | '''Description''' | ||
PRTCTRL lines (power management for USB devices) | |||
are susceptible to interference from the radiation of the GSM antenna. | |||
At high output power GSM and is close to the antenna location, interference lead to short-term withdrawal power with USB devices. | |||
''' | '''Symptoms''' | ||
If GSM is active and the signal level is poor, it can be observed under certain conditions: | |||
* | * disable and reconnect the Wi-Fi module | ||
* | * disconnect and reconnect external USB devices | ||
''' | '''How to fix''' | ||
* | * Change the location of the built-in GSM antenna in the housing | ||
* | * Take the built-in GSM antenna outside the case | ||
* | * Use external GSM antenna | ||
== 0350006: | = = = 0350006: Board power supply problems == | ||
''' | '''Revision''': | ||
3.5 | 3.5 | ||
''' | '''Description''' | ||
Incorrect C5 capacitor value in a very small number of boards shipped before June 10, 2014. | |||
''' | '''Symptoms''' | ||
There are problems with switching the Board on: the device turns on only after several switches of the on/off button. | |||
''' | '''How to fix''' | ||
* | * Change the capacitor C5 to the capacitor of capacity 1 µf (see figure) | ||
[[File:WB3top c5.jpg|thumb|500px| | [[File:WB3top c5.jpg|thumb|500px| C5 capacitor in WB SH rev. 3.5 (0350006)]] |
правки