Wiren Board 5: Модуль расширения ADC/en: различия между версиями

Материал из Wiren Board
(Новая страница: «Connection of the sensors type Pt100, Pt1000, thermistor from 100 ohms to 10K.»)
(Новая страница: «=== Operation ===»)
 
(не показаны 3 промежуточные версии этого же участника)
Строка 7: Строка 7:


2. "Current" jumper installed . Mode input current up to 70 mA. Measurement accuracy - 1%. Range - up to 70 mA.
2. "Current" jumper installed . Mode input current up to 70 mA. Measurement accuracy - 1%. Range - up to 70 mA.
For connecting current sensors.  
Connection of current sensors.  


3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k).
3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k).


Connection of the sensors type Pt100, Pt1000, thermistor from 100 ohms to 10K.   
Connection of sensors type Pt100, Pt1000, thermistor from 100 ohms to 10K.   


4. Подключение датчика Pt100, Pt1000 по трех проводной схеме. Замкнута только одна перемычка "Resistance 1". Схема подключения на рисунке.
4. Connect the sensor type Pt100, Pt1000 for three-wire system. Only one jumper closed "Resistance 1". Wiring in the figure.
Такое подключение позволяет учитывать сопротивление подводящих проводов, измерение получается более точным.   
This connection allows you to take into account the resistance of the lead wires, the measurement more accurate.   


O1 - GND.
O1 - GND.
Строка 21: Строка 21:




=== ПО ===
=== Operation ===


To be done
To be done

Текущая версия на 17:58, 14 января 2016

Другие языки:

Universal module ADC. 12 bits. Adjustable gain (1-12 times) can accurately measure even small voltage

Three modes of operation:

1. ADC mode (jumpers open). Range of measurement is 0-3,3 V.

2. "Current" jumper installed . Mode input current up to 70 mA. Measurement accuracy - 1%. Range - up to 70 mA. Connection of current sensors.

3. "Resistance" jumper installed . Measurement of resistance of 0.1-10 ohms. Measuring accuracy up to 0.2% (with R ~ 1k).

Connection of sensors type Pt100, Pt1000, thermistor from 100 ohms to 10K.

4. Connect the sensor type Pt100, Pt1000 for three-wire system. Only one jumper closed "Resistance 1". Wiring in the figure. This connection allows you to take into account the resistance of the lead wires, the measurement more accurate.

O1 - GND. O2 - INPUT2 О3 - INPUT1


Operation

To be done

Источник — https://wirenboard.com/wiki/index.php?title=Wiren_Board_5:_Модуль_расширения_ADC/en&oldid=6664