Wiren Board 5: Модуль расширения RS485-ISO/en: различия между версиями
| Строка 35: | Строка 35: | ||
Port is available in the system as | Port is available in the system as | ||
* /dev/ttyAPP2 - when installed in first slot for | * /dev/ttyAPP2 - when installed in the first slot for extension module (MOD1) | ||
* /dev/ttyAPP3 - when installed in second slot for | * /dev/ttyAPP3 - when installed in the second slot for extension module (MOD2) | ||
For work you need to disable hardware flow control. Additional configuration port as the RS485 is required. | For work you need to disable hardware flow control. Additional configuration port as the RS485 is required. | ||
Версия 15:22, 29 мая 2019
Module with galvanically isolated RS-485 interface.Isolation voltage: 1.5 kV The speed is up to 1 Mbit / s.
The module contains a 150 Ohm terminator between lines A and B. To enable it, you need to close the jumper on the top side of the board.
Pinout
RS485 signals go to extansion module terminals signed O1-O3.
| Terminal | Function |
|---|---|
| O1 | A (D+) |
| O2 | B (D-) |
| O3 | Isolated GND (Common, C) |
Configuration
Configuration of the web interface is carried out in the section Configs => Hardware Modules Configuration.
No special configuration is required. You need to make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None".
Operation
Port is available in the system as
- /dev/ttyAPP2 - when installed in the first slot for extension module (MOD1)
- /dev/ttyAPP3 - when installed in the second slot for extension module (MOD2)
For work you need to disable hardware flow control. Additional configuration port as the RS485 is required.