12 063
правки
Wiren Board 5: Модуль расширения RS485-ISO/en: различия между версиями
Wiren Board 5: Модуль расширения RS485-ISO/en (просмотреть исходный код)
Версия 15:23, 29 мая 2019
, 4 года назадНет описания правки
(Новая страница: «The module contains a 150 Ohm terminator between lines A and B. To enable it, you need to close the jumper on the top side of the board.») |
|||
| (не показано 6 промежуточных версий этого же участника) | |||
| Строка 6: | Строка 6: | ||
== Pinout == | == Pinout == | ||
[[Файл:RS-485.png|thumb|300px| | [[Файл:RS-485.png|thumb|300px|Extension module RS485-ISO]] | ||
RS485 signals | RS485 signals go to extansion module terminals signed O1-O3. | ||
{| class="wikitable" | {| class="wikitable" | ||
| Строка 25: | Строка 25: | ||
== | ==Configuration== | ||
Configuration of the web interface is carried out in the section Configs => Hardware Modules Configuration. | |||
No special configuration is required. | |||
You need to make sure that the corresponding slot (Internal slot 1 or Internal slot 2) is set to "None". | |||
== Operation == | |||
Port is available in the system as | Port is available in the system as | ||
* /dev/ttyAPP2 - when installed in first slot for | * /dev/ttyAPP2 - when installed in the first slot for extension module (MOD1) | ||
* /dev/ttyAPP3 - when installed in second slot for | * /dev/ttyAPP3 - when installed in the second slot for extension module (MOD2) | ||
For | For operation you need to disable hardware flow control. Additional configuration of the port as the RS485 is not required. | ||