История
22 апреля 2021
27 июня 2019
Новая страница: «No plans. WBE2-I-1WIRE is out of production, the new module WBE2-I-1WIRE-V2 is planned, which does not have this problem.»
−74
Нет описания правки
+10
Новая страница: «====fix===»
−51
Новая страница: «====Workarounds==== Use ports W1, W2 on the Wiren Board 6 when problems occur. Apply for a warranty replacement for a new version of the module.»
−104
Новая страница: «Work features of the applied chip DS2484 and protection circuits are the causes. The protection circuit limits the signal fronts when the DS2484 active pullup is…»
−288
Новая страница: «====Reasons and detailed description====»
−21
Новая страница: «The WBE2-I-1-WIRE module works worse on long lines than the W1-W2 ports on the Wiren Board 6.»
−36
Новая страница: «====Description==== See https://support.wirenboard.com/t/problemy-s-wbe2-i-1-wire/2967 (ru)»
−2
Новая страница: «==== Affected devices ====»
−27
Новая страница: «=== ERRE21W01: Unstable operation with long line ===»
−35
Новая страница: «== Known bugs and features ==»
−34
Новая страница: «The device is detected immediately, no reboot is required. After adding the device the output of the dmesg command will display a message <code>i2c-gpio mod1_i2c:…»
−178
Новая страница: «In the Internal slot 1 or 2 section (depending on the slot number) select "WBE2-I-1-WIRE" and click Save.»
−47
Новая страница: «Pinout: {| class="wikitable" !Terminal !Function |- |O1 |5Vout |- |O2 |1-W |- |O3 |GND |} == Configuration == Configuration is set in the web interface under Con…»
−90
Нет описания правки
Новая страница: «The signals are output to the terminals of the expansion module O1-O3.»
−20
Новая страница: «== Pinout ==»
−14
Новая страница: «thumb|200px| 1-Wire extension module The module contains GPIO protection, an active 1-Wire line pull-up and a current lim…»
−65
Новая страница: «== Hardware ==»
−23
Новая страница: «Wiren Board 6: 1-Wire extension module»
+3195