История
25 июля 2019
Новая страница: «See Supported devices»
+20
Новая страница: «== Peripheral connection == See Wiren Board 5: Connecting peripherals»
−5
Новая страница: « ==Software== Wiren Board software»
−20
Новая страница: «Wiren Board NETMON-2 can be equipped with built-in temperature and humidity sensor. For more information, see AM2320 sensor.»
−44
Новая страница: «== Temperature and humidity sensor ==»
−26
Новая страница: «thumb|700px| передняя панель {| class="wikitable" ! colspan="4" rowspan="1" |Relay outputs ! colspan="1"…»
−126
Новая страница: «The module inputs are galvanically isolated from the controller. Therefore, the ground GND of the module and the controller may be different. File:DI.png|300px|…»
−101
Новая страница: «==== Devices with open collector output. ==== The device and the module must have a common ground. Connect the open collector output to the Dx terminal.»
−107
Новая страница: «==== Sensors/counters with pulse outputs/buttons. ==== Such devices form a signal by closing two wires that are suitable for them. Connect one wire to the GND ter…»
−270
Нет описания правки
+3
Новая страница: «earth short |- |Operation condition |GND input lockout |- |Tripping current |1 mA |- |Minimum pulse width to trigger |10 ms |- |Minimum time between consecutive s…»
−230
Новая страница: «===Purpose=== Connection of pulse counters, buttons, switches, sensors with "dry contact"output. ===Technical parameters=== 8 inputs for connection of "dry contac…»
−403
Новая страница: «== Digital inputs ==»
−17
Новая страница: «Relays are connected in a phase break.File:Relay outputs.png|400px|thumb|none|connection diagram|link=http://contactless.ru/wiki/index.php/%D0%A4%D0%B0%D0%B9%D0…»
−40
Новая страница: «K and NO are closed |- |Maximum switching voltage, AC |250V |- |Maximum switching voltage, DC |30V |- |Maximum switching current, per channel (*) |10A |- |The cha…»
−364
Новая страница: «off,»
−5
Новая страница: «Current up to 10A per channel. The module has protection against sparking of the contacts. {| class="wikitable" !Parameter !Value |- |Number of outputs |4 |- |Out…»
−137
Новая страница: «SPST contact configuration (two contacts per relay: NO/COM).»
−37
Новая страница: «There are four groups of relay outputs, output on the connector terminals, on the front panel of the Wiren Board NETMON-2.»
−76
Новая страница: « thumb | 300px | The relay outputs on the front panel»
−28
Новая страница: «== External load switching ==»
−29
Новая страница: «Wiren Board NETMON-2 has one USB port (Host, type A) inside the case. The port is designed to connect Wi-Fi sticks, 3G modems, etc.»
−78
Новая страница: «== USB port==»
−5
Новая страница: «The GSM antenna is connected to the SMA connector on the front panel of the controller. If the GSM signal is weak, it is recommended to use a remote antenna and…»
−123
Новая страница: «== GSM/GPRS-modem ==»
−5
Новая страница: «There is protection against charging at low temperatures and overheating.»
−57
Новая страница: «The Wiren Board NETMON-2 can be equipped with one or two Li-Ion (Li-Pol) batteries with a maximum voltage of 4.2 V. When the power is connected, the battery is ch…»
−109
Новая страница: «=== Battery ===»
−15
Новая страница: «Power-over-Ethernet (Passive PoE) is supported via RJ45 connector on the front panel. Supports the standard voltage of 12V and 15V. See Power over Ethernet/en.»
−134
Новая страница: «The power connector for the standard jack 5.5x2.1mm is located on the front panel.»
−49
Новая страница: «The permissible power range is 5-22V. The average consumption of the device is 1.5-2 watts. But since the GSM module consumes up to 8W impulsively, it is recomme…»
−123
Новая страница: «===External power supply ===»
−27
Новая страница: «== Power Supply ==»
−2
Новая страница: «== Preparation for work == * Remove the top cover of the housing * Connect the backup power module to the controller * Install rack mounts * Install the top cover…»
−178
Новая страница: «== Package = = * Wiren Board NETMON-2 controller * terminals * 19" rack mount housing kit»
−106
Новая страница: «{| class="wikitable" border="1" width="700" style="text-align:center" ! colspan="2" |"'Other interfaces'" |- ||1xsound emitter||Buzzer. |- ||Real ti…»
−499
Новая страница: «{| class="wikitable" border="1" width="700" style="text-align:center" ! colspan="2" |"'Connect sensors'" |- |4x ADC||range 0-28V |- ||1xВходы д…»
−347
Новая страница: «{| class="wikitable" border="1" width="700" style="text-align:center" ! colspan="2" |'''General''' |- |Processor||[http://www.freescale.com/products/arm-processor…»
−749
Новая страница: « All inputs and outputs of the controller and extension modules are connected to detachable terminals on the front panel.»
−67
Новая страница: «5. 2х extension modules - опция»
−13
Новая страница: «4. Backup power module - optional.»
−28
Новая страница: «3. WBIO-DI-DR-8 »
+18
Новая страница: «2. WBIO-DO-R10A-4- 4 SPST 10A/230V relays»
−50
Новая страница: «1. Wiren Board 5»
+18
Новая страница: «The controller is identical in hardware to the set of:»
−41
Новая страница: «==Technical specifications==»
−29
Новая страница: «Designed for monitoring of network and telecommunication equipment, polling of sensors and counters, remote power management.»
−131
Новая страница: «Wiren Board NETMON-2 is a universal controller for automation with open software based on Linux, a built-in GSM modem and designed in a case for installation in a…»
−85
Новая страница: «Wiren Board NETMON-2»
+15 328