Translations:Controller hardware revisions/12/en

Материал из Wiren Board

No terminal strip R2 |

  • Removed R2 terminal strip
  • Added VOUT terminal strip - supply voltage output
  • Added jumpers to enable terminating resistors on RS-485/CAN lines
  • Moved the debug UART to USB connector
  • Stability is improved in the firmware recovery mode via microUSB
  • Mode is activated by the button flashing the FW, instead of the jumper
  • The power from the side I/O modules is not removed when the device is rebooted by the watchdog timer
  • Added MOD3 connector to connect mezzanine display module
  • Added support for a second USB-host in the configuration without Wi-Fi (available on request)

|55 |- |5.3 |11.2015 |Inscription Wiren Board 5 r.3 on the bottom side of the PCB.

Источник — https://wirenboard.com/wiki/index.php?title=Translations:Controller_hardware_revisions/12/en&oldid=52600