Translations:RS-485:Configuration via Web Interface/6/en
Set the port settings: speed (bit/s), number of bits in the packet, whether there is a parity bit, the number of stop bits - this information is specified in the documentation for the peripheral equipment. Then be sure to tip Enable port (with this setting, the port can be disabled if any hardware on it starts to fail).
NB. If you connect multiple devices to the same controller port, these settings must match.
![](/wiki/images/thumb/d/da/Rs-485-setup-port-settings.png/500px-Rs-485-setup-port-settings.png)
Settings forWB-MRM2 relay module are set