Wiren Board 6: Relay outputs module (WBE2-DO-R6C-1)
The module contains one SPDT configuration relay (switch contact). Max current: 6A for 230V AC or 30V DC. The maximum current is specified for the resistive load.
Pinout:
The relay module has 3 terminals: NO (Normally Open), NC (Normally Closed) and COM. In case of absence of a control signal on the relay, the NC terminal is connected to the COM terminal while there is no galvanic contact between the COM and NO. When the control signal is received, the relay is switched and the COM terminal is connected to the NO terminal.
| Terminal | Function |
|---|---|
| O1 | NO |
| O2 | NC |
| O3 | COM |
Configuration
Configuration is carried out in the web interface, section Configs => Hardware Modules Configuration.
Select "WBE2-DO-R6C-1: Single SPDT relay output extension module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save.
Once added, additional inputs appear in Devices next to the controller inputs.
The device is detected immediately, no reboot is required.
MQTT
| Slot | Channel | Topic |
|---|---|---|
| MOD1 | wb-gpio/MOD1_OUT1 | /devices/wb-gpio/controls/MOD1_OUT1 |
| MOD2 | wb-gpio/MOD2_OUT1 | /devices/wb-gpio/controls/MOD2_OUT1 |
Compatibility
The module is compatible with Wiren Board 6 controllers of all revisions. MOD1 or MOD2 slots are allowed for inserting the module.