Extension Module: LoRa WBE2R-R-LORA

From Wiren Board
This is the approved revision of this page, as well as being the most recent.
Other languages:

Buy online

WBE2R-R-LORA module back
WBE2R-R-LORA module front

Module description

WBE2R-R-LORA is built on Ebyte's E22-900T22S (datasheet).

The module organizes wireless communication between the controller and Wiren Board devices with LoRa. At the software level, work is carried out using the Modbus protocol.

Not suitable for devices with LoRaWan.

Installation

The module is compatible with controllers Wiren Board 6, Wiren Board 7 and Wiren Board 8 of all revisions, it can be installed:

  • Wiren Board 6.3–6.6 — up to 2 modules in slots MOD1-MOD2.
  • Wiren Board 6.7–7.x — up to 3 modules in slots MOD1-MOD3.
  • Wiren Board 8.4 — up to 3 modules in slots MOD1 -MOD3.

When ordering modules in a bundle with a Wiren Board controller, we install them at the factory - you just need to configure the modules in the controller's web interface.

If you bought the modules separately, install them yourself:

  1. Disassemble the controller case.
  2. Insert the module, observing the polarity: the protrusion on it should fit into the slot on the controller board.
    Extension module port numbering
  1. Fasten the SMA socket connector with nuts in the case hole above the Ethernet connectors (available in Wiren Board versions 6.5 and older, in earlier versions, drill yourself with a diameter of 6.5 mm).
  2. Reassemble the body. Keep an eye on the connecting cable from the module to the SMA socket: it must not be pinched, strongly bent, or get between the indicator and the light guide on the top cover.
  3. Screw the external antenna onto the SMA socket.
  4. When mounting in a metal shield, position the antenna outside for reliable radio communication.

Configuration

Change access level

Administrator level

To change the settings of the controller, you need the Administrator access level, which can be set in the SettingsPermissions section.

After completing the settings, we recommend that you set the access level to User or Operator - this will help you avoid making random mistakes when working with the web interface every day.

Settings

Connection of expansion modules in the web interface of the Wiren Board controller

After the module is physically connected, it must be added to the controller configuration:

  1. In the web interface, go to the section SettingsConfigsHardware Modules Configuration, select the Internal slot where the module is installed extensions.
  2. In the Module type drop-down list, select the name of the installed module.
  3. Press the Save button. The controller will enable the ports required for the module to work.

To remove a module, select the type None.

Work

Once configured, the port is available on the system as /dev/ttyMODx, where x is the slot number. This port must be specified when working with devices via modbus_client or the wb-mqtt-serial driver.

Device revisions

The batch number can be found on a sticker on the side of the case or on the PCB.

Revision Batch Release date Differences from previous revision
1.1 v1.1A/T August 2022
  • first versions