Wiren Board 5: Модуль расширения GPS/Glonass/en: различия между версиями
(Новая страница: « NTPD configuration with NMEA and PPS») |
(Новая страница: «Fix module SMA-socket in the drilled hole in the case with nuts and connect the external antenna.») |
||
(не показана 1 промежуточная версия этого же участника) | |||
Строка 61: | Строка 61: | ||
Fix module SMA-socket in the drilled hole in the case with nuts and connect the external antenna. | Fix module SMA-socket in the drilled hole in the case with nuts and connect the external antenna. | ||
При обратной сборке корпуса следите, чтобы соединительный кабель, ведущий от модуля к SMA-гнезду не попал между индикатором и пластиковым прозрачным световодом на верхней крышке Wiren Board. | |||
[[Получение_точного_времени_через_GPS/Glonass | [[Получение_точного_времени_через_GPS/Glonass| Настройка NTPD с NMEA и PPS]] |
Версия 14:48, 3 июля 2019
Module with GPS/Glonass module SIM68M. Model name: WBE-R-GPS
Determination of coordinates.
The time calibration signal.
Antenna
The module is not equipped with the antenna. Antenna connection is made through u.FL. connector.
When ordering the controller Wiren Board with the module, SMA type antenna connector installed on enclosure connector.
Power supply antenna: 3.3V.
Data
The data come from the module in the format NMEA. To work in Linux, you can use the software gpsd from our repository, or any other.
Data interchange with the module via the serial port.
Connection parameters: 9600 8N1.
PPS signal is input to the "CS" extension slot.
Operation in Wiren Board 5
Extension module | Serial port | PPS GPIO |
---|---|---|
MOD1 | /dev/ttyAPP2 | 91 |
MOD2 | /dev/ttyAPP3 | 83 |
Module installation
Appropriate instructions for disassembling the enclosure can be found here.
After the controller body is disassembled, proceed to the installation of the module and SMA-connector for connecting an external antenna.
In the side wall of the upper part of the controller body, drill a hole with a diameter of ~6.5 mm.
The location shown in the figure is the most convenient for mounting the connector: even if you have a WBMZ battery module installed, it will not prevent the connector from being attached.
Install GPS/GLONASS module, as shown in the figure, observing the polarity. See also Extension modules.
Fix module SMA-socket in the drilled hole in the case with nuts and connect the external antenna.
При обратной сборке корпуса следите, чтобы соединительный кабель, ведущий от модуля к SMA-гнезду не попал между индикатором и пластиковым прозрачным световодом на верхней крышке Wiren Board.