wb_editors
14 355
правок
WBIO-DO-R10R-4 Relay Module For Roller Shutter/en: различия между версиями
WBIO-DO-R10R-4 Relay Module For Roller Shutter/en (просмотреть исходный код)
Версия 12:51, 22 апреля 2021
, 3 года назадЧасть переводимой страницы Модуль релейных выходов 10A (roller shutter) (WBIO-DO-R10R-4).
(Новая страница: «== Connection to the controller == == Connection to the controller == See Модули ввода-вывода/en#Activating the modules in the controller web i…») |
FuzzyBot (обсуждение | вклад) (Часть переводимой страницы Модуль релейных выходов 10A (roller shutter) (WBIO-DO-R10R-4).) |
||
| (не показано 6 промежуточных версий 2 участников) | |||
| Строка 89: | Строка 89: | ||
See [[Модули ввода-вывода/en#Activating the modules in the controller web interface|Activating the modules in the web interface of the controller]]. In the Discrete I/O device, EXT(1-8)_DIR(1-4) and EXT(1-8)_ON(1-4) controls will be created after the module connection. DIR controls are responsible for direction selection (relay R2 on the circuit), and ON controls are responsible for switching on and off (relay R1 on the circuit). These controls in MQTT messages are called /devices/wb-gpio/controls/EXT'''x'''_DIR'''y''' and /devices/wb-gpio/controls/EXT'''x'''_ON'''y'''. | See [[Модули ввода-вывода/en#Activating the modules in the controller web interface|Activating the modules in the web interface of the controller]]. In the Discrete I/O device, EXT(1-8)_DIR(1-4) and EXT(1-8)_ON(1-4) controls will be created after the module connection. DIR controls are responsible for direction selection (relay R2 on the circuit), and ON controls are responsible for switching on and off (relay R1 on the circuit). These controls in MQTT messages are called /devices/wb-gpio/controls/EXT'''x'''_DIR'''y''' and /devices/wb-gpio/controls/EXT'''x'''_ON'''y'''. | ||
[[File:WBIO-DO-R10R-4-controls.png|300px|thumb|right| | [[File:WBIO-DO-R10R-4-controls.png|300px|thumb|right|Module's controls in the web interface]] | ||
== | == Module outputs — load connection== | ||
The phase wire is connected to the Lx terminals. Both terminals of the Lx contact group are connected on the board. NC and NO terminals are connected to the engine, setting the direction of rotation. The NO and NC outputs are protected by varistors. | |||
[[Файл:Roll.png|400px|thumb|none| | [[Файл:Roll.png|400px|thumb|none| Wiring diagram of the engine to the WBIO-DO-R10R-4 module]] | ||
== | == Images and drawings of the device == | ||
{{Wbincludes:WBPictures|1}} | {{Wbincludes:WBPictures|1}} | ||