translator, wb_editors
4390
правок
Translations:Первое включение Wiren Board Smart Home/3/en: различия между версиями
Translations:Первое включение Wiren Board Smart Home/3/en (просмотреть исходный код)
Версия 17:33, 7 декабря 2023
, 6 месяцев назадНет описания правки
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
| (не показано 5 промежуточных версий этого же участника) | |||
| Строка 1: | Строка 1: | ||
Before | Before you start | ||
#Be sure to | #Be sure to install a microSD card with the software image (included) into the device. | ||
#Install a | #Install a Micro-sized SIM card (if you plan to use the GSM module). | ||
#Check the switch | #Check the position of the switch.! N!#Connect the power supply. | ||
#Connect the power supply. | ==microSD card== | ||
Installed in the memory card slot ('''top''') with the contacts '''up'''. | |||
Installed in the | ===Micro-SIM card=== | ||
=== Micro-SIM card === | Installed in the Micro-SIM card slot ('''bottom''') with the contacts '''down''' with the cut corner inward. | ||
===Switch position=== | |||
=== Switch position === | The pressed side with a dot is '''off'''. | ||
The pressed side with a dot is 'off'. | Power supply | ||
There are three types: standard, DIN rail, PoE injector. | |||
There are three types: standard, DIN | '''Do not connect two different power supplies at the same time''', this will burn them and the controller. | ||
'''Do not connect two different power supplies at the same time''', | The standard power supply is connected to the corresponding connector. | ||
The standard power supply is connected to the | The DIN rail power supply is connected with wires to the large terminal blocks Vin and Gnd (next to with a relay, see the [http://wirenboard.com/wiki/index.php/%D0%A4%D0%B0%D0%B9%D0%BB:WB3.5.png diagram]) | ||
The power supply | Passive PoE power supply is connected Ethernet cable. | ||