Relay Module Modbus Management/en: различия между версиями

(Новая страница: «In the latest firmware versions (starting with 1.5.3) for WB-MR devices, it is now possible to remember the output status when power is off. The mode is controlle…»)
(Новая страница: «=== Digital inputs === The input state can be obtained by reading the Discrete Inputs 0—'''x''' registers (where x = '''(number of managed channels - 1)'''). If…»)
Строка 21: Строка 21:
In the latest firmware versions (starting with 1.5.3) for WB-MR devices, it is now possible to remember the output status when power is off. The mode is controlled by the Modbus register 6. If the register is set to '0', the state of the outputs will not be saved and all relays will be switched off when power is supplied. If the entry in the register unit, when the power is resumed everything is included before the crash relay is switched on again.
In the latest firmware versions (starting with 1.5.3) for WB-MR devices, it is now possible to remember the output status when power is off. The mode is controlled by the Modbus register 6. If the register is set to '0', the state of the outputs will not be saved and all relays will be switched off when power is supplied. If the entry in the register unit, when the power is resumed everything is included before the crash relay is switched on again.


=== Цифровые входы  ===
=== Digital inputs ===
Состояние входа можно получить чтением регистров Discrete Inputs 0—'''x''' (где x = '''(количество управляемых каналов - 1)'''). Если вход соединён с GND, значение регистра равно 1, если не соединён - 0.
The input state can be obtained by reading the Discrete Inputs 0—'''x''' registers (where x = '''(number of managed channels - 1)'''). If the input is connected to GND, the register value is 1, if not connected - it's 0.


=== Режимы взаимодействия цифровых входов с релейными выходами  ===
=== Режимы взаимодействия цифровых входов с релейными выходами  ===
Источник — https://wirenboard.com/wiki/Relay_Module_Modbus_Management/en