WBE2-I-CAN-ISO CAN Extension Module/en: различия между версиями
(Новая страница: «The module contains a 120 Ohm terminator between the H and L lines. To enable it, you need to close the jumper on the top side of the board.») |
(Новая страница: «== Operation in UART-CAN mode == The WBE2-I-CAN-ISO module operates in UART-CAN mode. The UART-CAN bus (also called sometimes simply CAN or RS-CAN) uses the physi…») |
||
Строка 12: | Строка 12: | ||
The module contains a 120 Ohm terminator between the H and L lines. To enable it, you need to close the jumper on the top side of the board. | The module contains a 120 Ohm terminator between the H and L lines. To enable it, you need to close the jumper on the top side of the board. | ||
== | == Operation in UART-CAN mode == | ||
The WBE2-I-CAN-ISO module operates in UART-CAN mode. The UART-CAN bus (also called sometimes simply CAN or RS-CAN) uses the physical can layer for the half-duplex serial port of the UART. | |||
Шина UART-CAN используется преимущественно в приборах учёта, таких как счётчики электроэнергии Меркурий. | Шина UART-CAN используется преимущественно в приборах учёта, таких как счётчики электроэнергии Меркурий. |
Версия 16:38, 26 июня 2019
Hardware
The module is built on a physical layer chip TJA1051. CAN signals are galvanically isolated from the controller.
The module contains a 120 Ohm terminator between the H and L lines. To enable it, you need to close the jumper on the top side of the board.
Operation in UART-CAN mode
The WBE2-I-CAN-ISO module operates in UART-CAN mode. The UART-CAN bus (also called sometimes simply CAN or RS-CAN) uses the physical can layer for the half-duplex serial port of the UART.
Шина UART-CAN используется преимущественно в приборах учёта, таких как счётчики электроэнергии Меркурий.
Модуль можно устанавливать в слоты MOD1 и MOD2.
Распиновка
Сигналы CAN выведены на клеммы модуля расширения O1-O3.
Распиновка:
Клемма | Функция |
---|---|
O1 | CAN L |
O2 | CAN H |
O3 | CAN GND (Isolated GND) |
Конфигурирование
Настройка осуществляется в веб-интерфейсе в раздел Configs => Hardware Modules Configuration.
В Internal slot 1/2 выбрать "WBE-I-CAN-ISO" и нажать Save.
Устройство определяется сразу же, перезагрузка не требуется.
Работа
В режиме UART-CAN модуль работает идентично модулю расширения RS-485, см. соответствующее описание.