WBE2-DO-R6C-1 Relay Extension Module/en: различия между версиями
(Новая страница: «Select "WBE2-DO-R6C-1: Single SPDT relay output extension module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save.») |
(Новая страница: «Once added, additional inputs appear in Devices next to the controller inputs.») |
||
Строка 35: | Строка 35: | ||
Select "WBE2-DO-R6C-1: Single SPDT relay output extension module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save. | Select "WBE2-DO-R6C-1: Single SPDT relay output extension module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save. | ||
Once added, additional inputs appear in Devices next to the controller inputs. | |||
Устройство определяется сразу же, перезагрузка не требуется. | Устройство определяется сразу же, перезагрузка не требуется. |
Версия 11:48, 27 июня 2019
The module contains one SPDT configuration relay (switch contact). Max current: 6A for 230V AC or 30V DC. The maximum current is specified for the resistive load.
Pinout:
The relay module has 3 terminals: NO (Normally Open), NC (Normally Closed) and COM. In case of absence of a control signal on the relay, the NC terminal is connected to the COM terminal while there is no galvanic contact between the COM and NO. When the control signal is received, the relay is switched and the COM terminal is connected to the NO terminal.
Terminal | Function |
---|---|
O1 | NO |
O2 | NC |
O3 | COM |
Configuration
Configuration is carried out in the web interface, section Configs => Hardware Modules Configuration.
Select "WBE2-DO-R6C-1: Single SPDT relay output extension module" in the Internal slot 1 or 2 section (depending on the slot number) and click Save.
Once added, additional inputs appear in Devices next to the controller inputs.
Устройство определяется сразу же, перезагрузка не требуется.
MQTT
Слот | Канал | Топик |
---|---|---|
MOD1 | wb-gpio/MOD1_OUT1 | /devices/wb-gpio/controls/MOD1_OUT1 |
MOD2 | wb-gpio/MOD2_OUT1 | /devices/wb-gpio/controls/MOD2_OUT1 |
Совместимость
Модуль совместим с контроллерами Wiren Board 6 всех ревизий. Допускается установка в MOD1 или MOD2.