Модули расширения/en: различия между версиями
Fizikdaos (обсуждение | вклад) (Новая страница: «To install the expansion module, the controller Wiren Board 5 in the case for DIN-rail is necessary to disassemble: remove the back cover and extract PCB. When co…») |
Fizikdaos (обсуждение | вклад) (Новая страница: «When ordering extension modules in set with the controller Wiren Board 5, expansion modules are installed by the manufacturer.») |
||
Строка 9: | Строка 9: | ||
When connecting module observe polarity module connector. | When connecting module observe polarity module connector. | ||
When ordering extension modules in set with the controller Wiren Board 5, expansion modules are installed by the manufacturer. | |||
Версия 16:16, 14 января 2016
This article describes the expansion modules to the controller Wiren Board 5.
Wiren Board 5 have two slots for expansion modules.
To install the expansion module, the controller Wiren Board 5 in the case for DIN-rail is necessary to disassemble: remove the back cover and extract PCB. When connecting module observe polarity module connector.
When ordering extension modules in set with the controller Wiren Board 5, expansion modules are installed by the manufacturer.
См. соответствующие статьи для описания подключения и работы в ПО:
- Модуль расширения RS-232
- Модуль расширения CAN (Изолированный)
- Модуль расширения RS-485 (Изолированный)
- Модуль расширения АЦП - (в разработке) входы напряжения, входы 0-20мА, датчики PT100 и PT1000
- Модуль расширения ЦАП - (в разработке) выходы 0-10В
- Модуль входов "сухой контакт"
- Модуль расширения GPS/Glonass
- Модуль расширения 1-Wire