Translations:WB-MSx Consumer IR Manual/20/en: различия между версиями
(Новая страница: «== Operating mode == === Recording the signal to the RAM from the remote control === To write a signal (only one) from the remote control to the RAM without putti…») |
Admin (обсуждение | вклад) |
||
| Строка 2: | Строка 2: | ||
=== Recording the signal to the RAM from the remote control === | === Recording the signal to the RAM from the remote control === | ||
To write a signal (only one) from the remote control to the RAM without putting it in the ROM - write 1 in the flag register at <code>5001</code>. Further actions occur in the same way as described above to record the signal in ROM. After the recording is stopped in the storage registers at <code>2000</code>, the signal will be stored as a sequence of numbers. You can edit this sequence as described above. Note: the contents of these storage registers are not stored when the device is powered off! | To write a signal (only one) from the remote control to the RAM without putting it in the ROM - write 1 in the flag register at <code>5001</code>. Further actions occur in the same way as described above to record the signal in ROM. After the recording is stopped in the storage registers at <code>2000</code>, the signal will be stored as a sequence of numbers. You can edit this sequence as described above. Note: the contents of these storage registers are not stored when the device is powered off! | ||
=== Playing a signal from memory === | |||
To play the signal from memory, write 1 to the flag register at <code>5002</code>. The signal recorded in the storage registers starting with <code>2000</code>will be played. In the absence of the marker of the end of the command will return an error. While the signal is playing, the flag register at <code>5002</code> will be set to 1 and then set to 0. While the signal is being played, no other operations with the IR transceiver via Modbus will be available. | To play the signal from memory, write 1 to the flag register at <code>5002</code>. The signal recorded in the storage registers starting with <code>2000</code>will be played. In the absence of the marker of the end of the command will return an error. While the signal is playing, the flag register at <code>5002</code> will be set to 1 and then set to 0. While the signal is being played, no other operations with the IR transceiver via Modbus will be available. | ||
Текущая версия на 16:52, 9 июня 2020
Operating mode
Recording the signal to the RAM from the remote control
To write a signal (only one) from the remote control to the RAM without putting it in the ROM - write 1 in the flag register at 5001. Further actions occur in the same way as described above to record the signal in ROM. After the recording is stopped in the storage registers at 2000, the signal will be stored as a sequence of numbers. You can edit this sequence as described above. Note: the contents of these storage registers are not stored when the device is powered off!
Playing a signal from memory
To play the signal from memory, write 1 to the flag register at 5002. The signal recorded in the storage registers starting with 2000will be played. In the absence of the marker of the end of the command will return an error. While the signal is playing, the flag register at 5002 will be set to 1 and then set to 0. While the signal is being played, no other operations with the IR transceiver via Modbus will be available.