Translations:Первое включение Wiren Board Smart Home/3/en: различия между версиями
Matveevrj (обсуждение | вклад) |
Matveevrj (обсуждение | вклад) |
||
Строка 3: | Строка 3: | ||
#Install a Micro-sized SIM card (if you plan to use the GSM module). | #Install a Micro-sized SIM card (if you plan to use the GSM module). | ||
#Check the position of the switch.! N!#Connect the power supply. | #Check the position of the switch.! N!#Connect the power supply. | ||
microSD card | |||
Installed in the memory card slot ('''top''') with the contacts '''up'''. | Installed in the memory card slot ('''top''') with the contacts '''up'''. | ||
Micro-SIM card | |||
Installed in the Micro-SIM card slot ('''bottom''') with the contacts '''down''' with the cut corner inward. | Installed in the Micro-SIM card slot ('''bottom''') with the contacts '''down''' with the cut corner inward. | ||
Switch position | |||
The pressed side with a dot is '''off'''. | The pressed side with a dot is '''off'''. | ||
Power supply | |||
There are three types: standard, DIN rail, PoE injector. | There are three types: standard, DIN rail, PoE injector. | ||
'''Do not connect two different power supplies at the same time''', this will burn them and the controller. | '''Do not connect two different power supplies at the same time''', this will burn them and the controller. |
Версия 17:32, 7 декабря 2023
Before you start
- Be sure to install a microSD card with the software image (included) into the device.
- Install a Micro-sized SIM card (if you plan to use the GSM module).
- Check the position of the switch.! N!#Connect the power supply.
microSD card Installed in the memory card slot (top) with the contacts up. Micro-SIM card Installed in the Micro-SIM card slot (bottom) with the contacts down with the cut corner inward. Switch position The pressed side with a dot is off. Power supply There are three types: standard, DIN rail, PoE injector.
Do not connect two different power supplies at the same time, this will burn them and the controller.
The standard power supply is connected to the corresponding connector. The DIN rail power supply is connected with wires to the large terminal blocks Vin and Gnd (next to with a relay, see the diagram) Passive PoE power supply is connected Ethernet cable.