Wiren Board 6: Relay outputs module (WBE2-DO-R6C-1)
The module contains one SPDT configuration relay (switch contact). Max current: 6A for 230V AC or 30V DC. The maximum current is specified for the resistive load.
Pinout:
The relay module has 3 terminals: NO (Normally Open), NC (Normally Closed) and COM. In case of absence of a control signal on the relay, the NC terminal is connected to the COM terminal while there is no galvanic contact between the COM and NO. When the control signal is received, the relay is switched and the COM terminal is connected to the NO terminal.
Terminal | Function |
---|---|
O1 | NO |
O2 | NC |
O3 | COM |
Configuration
Configuration is carried out in the web interface, section Configs => Hardware Modules Configuration.
В разделе Internal slot 1 или 2 (в зависимости от номера слота) выбрать "WBE2-DO-R6C-1: Single SPDT relay output extension module" и нажать Save.
После добавления дополнительный релейный выход появляется в Devices рядом с выходами контроллера.
Устройство определяется сразу же, перезагрузка не требуется.
MQTT
Слот | Канал | Топик |
---|---|---|
MOD1 | wb-gpio/MOD1_OUT1 | /devices/wb-gpio/controls/MOD1_OUT1 |
MOD2 | wb-gpio/MOD2_OUT1 | /devices/wb-gpio/controls/MOD2_OUT1 |
Совместимость
Модуль совместим с контроллерами Wiren Board 6 всех ревизий. Допускается установка в MOD1 или MOD2.