Translations:Controller hardware revisions/12/en
Версия от 14:12, 28 июня 2019; RomanKulibaba (обсуждение | вклад) (Новая страница: «No terminal strip R2 | * Removed R2 terminal strip * Added VOUT terminal strip - supply voltage output * Added jumpers to enable terminating resistors on RS-485/C…»)
No terminal strip R2 |
- Removed R2 terminal strip
- Added VOUT terminal strip - supply voltage output
- Added jumpers to enable terminating resistors on RS-485/CAN lines
- Moved the debug UART to USB connector
- Stability is improved in the firmware recovery mode via microUSB
- Mode is activated by the button flashing the FW, instead of the jumper
- The power from the side I/O modules is not removed when the device is rebooted by the watchdog timer
- Added MOD3 connector to connect mezzanine display module
- Added support for a second USB-host in the configuration without Wi-Fi (available on request)
|55 |- |5.3 |11.2015 |Inscription Wiren Board 5 r.3 on the bottom side of the PCB.