Extension modules
Версия от 16:16, 14 января 2016; Fizikdaos (обсуждение | вклад) (Новая страница: «See relevant articles to describe the connection and operation in the software:»)
This article describes the expansion modules to the controller Wiren Board 5.
Wiren Board 5 have two slots for expansion modules.
To install the expansion module, the controller Wiren Board 5 in the case for DIN-rail is necessary to disassemble: remove the back cover and extract PCB. When connecting module observe polarity module connector.
When ordering extension modules in set with the controller Wiren Board 5, expansion modules are installed by the manufacturer.
See relevant articles to describe the connection and operation in the software:
- Модуль расширения RS-232
- Модуль расширения CAN (Изолированный)
- Модуль расширения RS-485 (Изолированный)
- Модуль расширения АЦП - (в разработке) входы напряжения, входы 0-20мА, датчики PT100 и PT1000
- Модуль расширения ЦАП - (в разработке) выходы 0-10В
- Модуль входов "сухой контакт"
- Модуль расширения GPS/Glonass
- Модуль расширения 1-Wire