Translations:Первое включение Wiren Board Smart Home/3/en

Версия от 17:24, 7 декабря 2023; Matveevrj (обсуждение | вклад)

Before work

  1. Be sure to insert the software image microSD card (included) into the device.
  2. Install a micro SIM card (if you plan to use a GSM module).
  3. Check the switch position.
  4. Connect the power supply.

microSD card

Installed in the connector for memory card (top) contacts up.

Micro-SIM card

It is installed in the connector for Micro-SIM card ("lower") contacts down cut corner inside.

Switch position

The pressed side with a dot is 'off'.

Power supply

There are three types: standard, DIN-rail, PoE-injector. Do not connect two different power supplies at the same time, it will burn them and the controller. The standard power supply is connected to the appropriate connector. The power supply on a DIN rail connect the wires to the big terminals Vin and Gnd (next to the relays, see [http://wirenboard.com/wiki/index.php/%D0%A4%D0%B0%D0%B9%D0%BB:WB3.5.png diagram) The Passive PoE power supply is connected by an Ethernet cable.

Источник — https://wirenboard.com/wiki/index.php?title=Translations:Первое_включение_Wiren_Board_Smart_Home/3/en&oldid=77685