Extension modules

Installing extension module

Pinout connector for extension modules

Wiren Board 5 have two slots for extension modules.

When ordering extension modules in set with the controller Wiren Board 5, expansion modules are installed by the manufacturer.

To install the expansion module, the controller Wiren Board 5 in the case for DIN-rail is necessary to disassemble: remove the back cover and extract PCB. When connecting module observe polarity module connector.

See relevant articles to describe the connection and operation in the software:

• RS-232 Extension module
• CAN (Isolated) Extension module
• RS-485 (Isolated) Extension module
• ADC Extension module - (in developing) voltage inputs, inputs 0-20mA, PT100 and PT1000 sensors
• DAC Extension module - (in developing) 0-10V outputs
• Module for inputs "dry contact"
• GPS/Glonass Extension module
• 1-Wire Extension module