Peripherals

Peripherals

Displays

Different screens and displays can be connected via serial interface. Connection of character screens in parallel mode is also supported.

Serial TFT

Many displays are supported by the driver https://github.com/notro/fbtft , which is not yet integrated into the mainline kernel. List of supported driver models: https://github.com/notro/fbtft/wiki/LCD-Modules

Below is a list of screens tested with Wiren Board.

• 2.2’ TFT LCD: TFT01-2.2 SP from Elecfreacs and clones, 320x240 color, chip ILI9341,starting from $6.5 at retail

Zigbee MiWi transciever

MOD-MRF24J40

Interfaces

RS-232

• MOD-RS232 - TX/RX only. Connect up to two modules to the Board. The connection uses UEXT1 ( Debug UART must be disabled) and UEXT2 (cannot be used simultaneously with RS-485)
• Adapters USB-RS-232. Up to two cables without using an external USB hub. Possible programmatic power supply reboot

RS-485

• https://www.olimex.com/Products/Modules/Interface/MOD-RS485-ISO/ galvanically isolated, full/half duplex, I2C interface, can be used in conjunction with Debug UART and RS-485. It is possible to connect more than two devices.
• https://www.olimex.com/Products/Modules/Interface/MOD-RS485 - half duplex, uses UART. Up to two modules.

Contactless card readers and keyboards

Wiegand

• Connect the lines D0 and D1 of the readers to the GPIO through a resistor 1-20 kom! (on Wiren Board 2.8)
• See https://github.com/contactless/wirenboard/tree/master/examples/wiegand
• See https://github.com/contactless/wiegand-linux

Приборы учёта

Приборы учёта с импульсным выходом

Modbus-устройства

Устройства с интерфейсом Modbus

Кнопки и сухие контакты

См. http://contactless.ru/forums/topic/%D0%BF%D0%BE%D0%B4%D0%BA%D0%BB%D1%8E%D1%87%D0%B5%D0%BD%D0%B8%D0%B5-%D0%BA%D0%BD%D0%BE%D0%BF%D0%BE%D0%BA-%D0%BA-gpio/#post-2384 См. Приборы учёта с импульсным выходом