Translations:WBE2R-R-LORA v.1 Extension Module/4/en

Installation

When ordering modules bundled with the Wiren Board controller, we install them in production - you only need to configure the modules in web interface of the controller.

If you bought the modules separately, install them yourself:

1. Disassemble the controller case.
2. Insert the module, observing the polarity: the protrusion on it must fit into the groove on the controller board.

Удалите мешающий выступ на корпусе контроллера Wiren Board 6.7–7.x при установке модуля в MOD3

Модуль совместим с контроллерами Wiren Board 6, Wiren Board 7 и Wiren Board 8 всех ревизий, его можно установить:

• Wiren Board 6.3–6.6 — до 2 модулей в слоты MOD1­-MOD2.
• Wiren Board 6.7–7.x — до 3 модулей в слоты MOD1­-MOD3, при установке в MOD3 потребуется удалить мешающий выступ на корпусе контроллера с помощью кусачек или напильника.
• Wiren Board 8.4 — до 3 модулей в слоты MOD1­-MOD3.

Configuration

Change access level

Administrator level

To change the settings of the controller, you need the Administrator access level, which can be set in the Settings → Permissions section.

After completing the settings, we recommend that you set the access level to User or Operator - this will help you avoid making random mistakes when working with the web interface every day.

Settings

Connection of expansion modules in the web interface of the Wiren Board controller

After the module is physically connected, it must be added to the controller configuration:

1. In the web interface, go to the section Settings → Configs → Hardware Modules Configuration, select the Internal slot where the module is installed extensions.
2. In the Module type drop-down list, select the name of the installed module.
3. Press the Save button. The controller will enable the ports required for the module to work.

To remove a module, select the type None.