WBIO-DO-HS-8 Discrete Outputs/en: различия между версиями
(Новая страница: «the module requires an external power supply to the terminals '''Vin''' and '''GND''' (11 to 45V).») |
(Новая страница: «The ground of the module must be connected to the ground of the controller!») |
||
| Строка 76: | Строка 76: | ||
the module requires an external power supply to the terminals '''Vin''' and '''GND''' (11 to 45V). | the module requires an external power supply to the terminals '''Vin''' and '''GND''' (11 to 45V). | ||
The ground of the module must be connected to the ground of the controller! | |||
[[Файл:HSx.png|300px|thumb|none|Схема работы модуля High Side Outputs. ]] | [[Файл:HSx.png|300px|thumb|none|Схема работы модуля High Side Outputs. ]] | ||
Версия 16:55, 15 июля 2019
Purpose
The module is designed to control low-voltage loads: relays, low-voltage motors, signal lamps, etc
Technical specifications
Contains 8 outputs such as "High Side Switch" - when you turn on channel Vin voltage is supplied to the output.
The module is based on BTS4880R chip.
The outputs are protected against overload, short circuit, overheating, spikes when controlling the inductive load.
| Parameter | Value |
|---|---|
| Number of outputs | 8 |
| Number of groups | 1 |
| Output type | High Side Switch |
| Switching voltage | 11 - 45 V DC |
| Maximum switching current, per channel | 0.6 A |
| Leakage current disabled output (each output) | <10 µa |
| The channel resistance in the open state | 200 mOhm |
| Module type | O (non-inverted addr.) |
| Maximum power consumption | 0.025 W |
| Width, DIN units | 2 |
| Size | 36.3x90.2x57.5 mm |
| Terminals and wire section | |
|---|---|
| Recommended wire cross-section with TSVI, mm2 | 0,75 — 1 |
| Length of the standard sleeve NSVE, mm | 8 (10 for adjusting screwless terminal blocks) |
| Torque of screws, N∙m | 0,2 (for screw terminals) |
Connection to the controller
See Activating the modules in the web interface of the controller
Load connection
the module requires an external power supply to the terminals Vin and GND (11 to 45V).
The ground of the module must be connected to the ground of the controller!
Изображения и чертежи устройства
По ссылкам ниже вы можете скачать изображения и чертежи устройства WBIO-DO-SSR-8.
Corel Draw 2018: WBIO-DO-SSR-8.cdr.zip
Corel Draw PDF: WBIO-DO-SSR-8.cdr.pdf
Autocad 2013 DXF: Мы еще не подготовили чертеж этого устройства. Вы можете запросить чертеж устройства "Digital output module WBIO-DO-SSR-8" на портале техподдержки Wiren Board (необходима регистрация).