wb_editors
14 355
правок
(Новая страница: «WBIO-DO-R1G-16 I/O Module») |
FuzzyBot (обсуждение | вклад) (Часть переводимой страницы WBIO-DO-R1G-16 I/O Module.) |
||
(не показано 17 промежуточных версий 2 участников) | |||
Строка 1: | Строка 1: | ||
<languages/> | <languages/> | ||
{{#vardefine:ProductFullName1|Module relay outputs WBIO-DO-R1G-16}} {{#vardefine:FileName1|WBIO-DO-R1G-16}} {{#vardefine:ProductName1|WBIO-DO-R1G-16}} | |||
'''[https://wirenboard.com/ | '''[https://wirenboard.com/en/product/WBIO-DO-R1G-16/ Buy online]''' | ||
[[ | [[File:WBIO-DO-R1G-16.png|250px|thumb|WBIO-DO-R1G-16 module]] | ||
== | == Purpose== | ||
Control of contactors, warning lights, etc. | |||
== | == Technical specifications == | ||
Contains 16 HF49FD relays [[http://www.hongfa.com/pro/pdf/HF49FD_en.pdf (Datasheet)]] with the configuration of contacts SPST (two contacts on the relay: NO/COM). | |||
The relays are combined into two groups of 8 pieces, each group has one common COM pin: the upper COM pin for relays K1 — K8 and the lower COM pin for relays K9 — K16. There's no connection between groups, so the first group can switch one voltage source, and the second - the other. | |||
Rated channel current: 1 A. | |||
The module has protection against sparking of the contacts. | |||
Our detailed article in russian on habr.com about the choice of relay parameters for the switched load: https://habr.com/ru/company/wirenboard/blog/422197/ | |||
{| class="wikitable" | {| class="wikitable" | ||
! | !Parameter | ||
! | !Value | ||
|- | |- | ||
| | |Number of outputs | ||
|16 | |16 | ||
|- | |- | ||
| | |Number of output groups | ||
|2 | |2 | ||
|- | |- | ||
| | |Output type | ||
| | |mechanical relay | ||
|- | |- | ||
| | |Contact configuration | ||
|SPST, | |SPST, normally open | ||
states: | |||
* | *off. | ||
* | *Kx and NO closed | ||
|- | |- | ||
| | |Maximum switching voltage, alternating current | ||
|250 | |250 V | ||
|- | |- | ||
| | |Maximum switching voltage, direct current | ||
|30 | |30 Volts | ||
|- | |- | ||
| | |Maximum switching current, per channel (*) | ||
|5 | |5 A | ||
|- | |- | ||
| | |Maximum switching current, | ||
the channels in one group | |||
|10 | |10 A | ||
|- | |- | ||
| | |The channel resistance in the open state | ||
|< 50 | |< 50 mW | ||
|- | |- | ||
| | |Voltage isolation between the controller and the output | ||
|2000 | |2000 V (RMS.) | ||
|- | |- | ||
| | |Lifetime: number of switches | ||
for load 3 A 230 V AC, cos φ = 1 | |||
|100 000 | |100 000 | ||
|- | |- | ||
| | |Lifetime: number of switches | ||
for load 0.1 A 230 V AC, cos φ = 1 (**) | |||
|1 000 000 | |1 000 000 | ||
|- | |- | ||
| | |Module type | ||
|"O" (non-inverted address scheme) | |"O" (non-inverted address scheme) | ||
|- | |- | ||
| | |Maximum power consumption | ||
|1 | |1 W | ||
|- | |- | ||
| | |Width, DIN units | ||
|3 | |3 | ||
|- | |- | ||
| | |Size | ||
|53,3x90,2x57,5 | |53,3x90,2x57,5 mm | ||
|} | |} | ||
<nowiki>*</nowiki>) | <nowiki>*</nowiki>) Maximum switching current is specified for 230 VAC resistive load. | ||
<nowiki>**</nowiki>) | <nowiki>**</nowiki>) Calculated value | ||
{| class="wikitable" | {| class="wikitable" | ||
!colspan="2" | ''' | !colspan="2" | '''Terminals and wire section''' | ||
|- | |- | ||
|| | || The recommended wire cross section with pin bushing insulated tip, mm<sup>2</sup> || 2,5 | ||
|- | |- | ||
|| | || Standard sleeve length of pin bushing insulated tip, mm || 8 | ||
|- | |- | ||
|| | ||Tightening torque of screws, Н∙м || 0,5 | ||
|- | |- | ||
|} | |} | ||
[[File:DIN 3U.png |300px|thumb|right| | [[File:DIN 3U.png |300px|thumb|right|Dimensions]] | ||
== | == Connection to the controller == | ||
See [[Модули ввода-вывода/en#Activating the modules in the controller web interface|Activating the modules in the web interface of the controller]] | |||
== | == Load connection== | ||
Relays are connected in a phase break. | |||
[[Файл:Relay outputs.png|400px|thumb|none| | [[Файл:Relay outputs.png|400px|thumb|none|Connection scheme]] | ||
== Device pictures and drawings == | |||
== | |||
{{Wbincludes:WBPictures|1}} | {{Wbincludes:WBPictures|1}} |