Wiren Board NETMON-1/en: различия между версиями

Connect the ground of the network to the contacts GND (7-8@I2, etc.) or common ground bus.

Data line to "1-Wire" contact ( 4@I2).

Power line to contact "5V" (1-2@I2) (internal power supply).

External 1-Wire bus power supplies are allowed.

When using a passive power supply pin of each sensor is connected to the earth wire.

In this case, the bus consists two wires attached, respectively, to '1-Wire "and" GND ".

=== RS-485 network connection ===

See [[RS-485/en|RS-485]].

The Wiren Board NETMON-1 has two RS-485 ports on the "I6" and "I8" connectors.  

Lines A B are connected to terminals A and B respectively.  

== Temperature and humidity sensor ==

Wiren Board NETMON-1 can be equipped with a built-in temperature and humidity sensor. For more information, see [[Sensor SHT1x/en|SHT1x Sensor]].

==Software==

[[Программное обеспечение Wiren Board/en|Wiren Board Software ]]

[[ПО_МКА-3/en| МКА-3 Software]]