История
26 апреля 2019
25 апреля 2019
Нет описания правки
+12
Новая страница: «sc16is7x2 driver exports 8 GPIOs into the standard Linux sysfs-interface under numbers 120-127.»
−48
Новая страница: «7 GPIO lines are displayed on the holes in increments of 2.54'' on the mainboard of the Wiren Board controller. A PPS signal from a GPS modem is connected to one…»
−20
Новая страница: «<b> /dev/ttyNSC1 </b> port in Linux. The SIM68V GPS module is connected to the TX/RX lines of the port.»
−11
Новая страница: «The device in Linux: <b>/dev/ttyNSC0</b>. TX/RX port lines are output to UEXT UEXT2. A half-duplex Special:MyLanguage/RS-485|…»
−259
Новая страница: «== In Wiren Board 2.8==»
Новая страница: «The control signals/GPIO and RX/TX lines are output to the WB SH 3.5: UEXT2 connector. The connector is designed to use GPIO, as well as…»
−102
Новая страница: «The device in Linux: <b>/dev/ttyNSC1</b>. Half-duplex RS-485-transceiver. RS-485 port-2 (the blue pair of terminals).»
−52
Новая страница: «The direction of operation of the transceiver is set by the chip using the RTS signal automatically, the hardware flow control must be disabled. RS-485 mode may n…»
−167
Новая страница: «The device in Linux: <b>/dev/ttyNSC0</b>. Half-duplex RS-485-transceiver. RS-485 port-1 (the green pair of terminals).»
−55
Новая страница: «== In Wiren Board Smart Home 3.5 ==»
Новая страница: «sc16is7x2 driver exports 8 GPIOs into the standard Linux sysfs-interface under numbers 120-127.»
−48
Нет описания правки
−8
Новая страница: «Linux uses the драйвер sc16is7x2,which has not been ported to upstream yet. It can be found in our Linu…»
−110
Новая страница: «Connected to SPI. GPIO is used as chip-select.»
−43
Новая страница: «two fully-functional UARTs with hardware flow control, up to 8 GPIOs.»
+9
Новая страница: «==Description==»
−5
Новая страница: «'''SC16IS752''' is a chip that controls serial ports in some versions of the Wiren Board.»
−73
Новая страница: «SC16IS752»
+3719