Translations:Работа с GPIO/34/en: различия между версиями

Translations:Работа с GPIO/34/en (просмотреть исходный код)

14 байт добавлено , 5 лет назад

Нет описания правки

12 063

правки

Версия 13:19, 19 января 2016 (просмотреть исходный код) Fizikdaos (обсуждение \| вклад) (Новая страница: «Pointing to the GPIO Device Tree you need to configure the GPIO to work in a mode of software SPI, I2C, GPIO to be used as the source of the interrupt, etc. For e…»)		Текущая версия на 17:57, 24 апреля 2019 (просмотреть исходный код) RomanKulibaba (обсуждение \| вклад)
Строка 1:		Строка 1:
	~~Pointing~~ to the GPIO Device Tree ~~you need~~ to configure the GPIO to work in a mode of software SPI, I2C, GPIO to be used as the source of the interrupt, etc.		It's necessary to place the GPIO in Device Tree to configure the GPIO to work in a mode of software SPI, I2C, for GPIO to be used as the source of the interrupt, etc.
	For example on a pin 10 @ UEXT1 (CS) and pins 5 @ UEXT2 (SCL), 6 @ UEXT2 (SDA), 10 @ UEXT2 (CS) ~~derived~~ processor ~~GPIO~~ lines. They can be configured to use such as a chip-select for as SPI or I2C.		For example on a pin 10 @ UEXT1 (CS) and pins 5 @ UEXT2 (SCL), 6 @ UEXT2 (SDA), 10 @ UEXT2 (CS) GPIO processor lines are derived. They can be configured to use such as a chip-select for SPI or as I2C.