Translations:WB Debug Console/105/en: различия между версиями

Translations:WB Debug Console/105/en (просмотреть исходный код)

117 байт добавлено , 5 лет назад

Нет описания правки

12 063

правки

@@ Строка 1: / Строка 1: @@
-Previous models of Wirenboard controller (including the 5.6 rev) got three pins GND, RX и TX for the debug UART onboard. To use them you need a special USB-UART or RS-232-UART adapter.
+== Physical implementation of the debug console port ==
-New versions of the controller (beginning from 5.8) have USB-UART adapter integrated on the board. You can use the Micro-USB socket to connect to the debug UART of new controllers. The Micro-USB socket you need is called "Debug USB".
+Physically in different versions of the controller the debug port is implemented on different:
+* for versions ''WB 6 and later' it looks like a Micro-USB connector (signed 'Debug Console');
+* for versions ''WB 5.8 and later' it looks like a Micro-USB connector (signed 'Debug Console' or 'Debug USB');
+* for versions '''WB 5.6''' and earlier, up to version '''2.8''' it looks like a three-pin connector (signed ''Debug UART'').
+Programmatically, in all cases, it is a serial port.