RS-485/en: различия между версиями
Строка 6: | Строка 6: | ||
You can connect the following devices to the Wiren Board controller Via the RS-485 bus: | You can connect the following devices to the Wiren Board controller Via the RS-485 bus: | ||
* [[Special:MyLanguage/Периферийные устройства с интерфейсом RS-485 серии WB-xxxx | devices of our production with the RS-485 interface | * [[Special:MyLanguage/Периферийные устройства с интерфейсом RS-485 серии WB-xxxx | devices of our production with the RS-485 interface]], | ||
* Mercuriy and Milur counters, | * Mercuriy and Milur counters, | ||
* [[Поддерживаемые устройства/en#Connected via RS-485 | some other devices]]. | * [[Поддерживаемые устройства/en#Connected via RS-485 | some other devices]]. |
Версия 17:18, 3 июня 2019
RS-485 is two-wire bus communication standard.
Up to 256 devices can be connected to the bus. Transmission speed is up to 115200 bit/s.Line length is up to 1200 meters.
You can connect the following devices to the Wiren Board controller Via the RS-485 bus:
- devices of our production with the RS-485 interface,
- Mercuriy and Milur counters,
- some other devices.
Basics of the RS-485 interface
See article Basics of RS-485 interface operation.
The Wiren Board devices use the Modbus Protocol on top of the RS-485. Протокол Modbus.
How to lay the bus correctly
See article RS-485:Physical connection.
Adding a device to the web interface
After connecting the RS-485 device to the controller, you need to configure it to appear in the web interface. See the instructions in article RS-485:Настройка через веб-интерфейс.
Working with RS-485 port of the controller using its own software
- As default wb-mqtt-serial driver manages devices connected to Wiren Board controller via RS-485(the previous driver was wb-homa-modbus). It allows you to work with connected RS-485 devices via MQTT message system.
- If you want to work with RS-485 port directly without using this driver - disable it, otherwise it will write to RS-485 port.
- Работа с последовательным портом из Linux
- Доступ к порту RS-485 контроллера Wiren Board с компьютера
- UART Communication Settings for Modbus devices