wb_editors
14 355
правок
(Новая страница: «Wiren Board 6: WBE2S-MICROSD Extension Module») |
FuzzyBot (обсуждение | вклад) м (FuzzyBot переименовал страницу Wiren Board 6: WBE2S-MICROSD Extension Module/en в WBE2S-MICROSD MicroSD Extension Module/en без оставления перенаправления: Часть переводимой страницы Wiren Board 6: WBE2S-MICROSD Extension Module.) |
||
(не показано 12 промежуточных версий 1 участника) | |||
Строка 1: | Строка 1: | ||
<languages/> | <languages/> | ||
== | == Hardware == | ||
<div class="tright" style="clear:none">[[Файл:WBE3-MICROSD.png|thumb|200px| | <div class="tright" style="clear:none">[[Файл:WBE3-MICROSD.png|thumb|200px| WBE2S-MICROSD back side]]</div> | ||
<div class="tright" style="clear:none">[[Файл:WBE3-MICROSD2.png|thumb|200px| | <div class="tright" style="clear:none">[[Файл:WBE3-MICROSD2.png|thumb|200px|WBE2S-MICROSD front side]]</div> | ||
Can be installed only in MOD3 slot of the Wiren Board 6 controller. | |||
microSD | the microSD card is inserted into the slot under the top cover of the controller. | ||
To access the connector, pry the cover off with a flat screwdriver and remove it. | |||
The module comes without a microSD card! | |||
Supported cards: microSD, microSDHC. | |||
Maximum interface speed supported: "high speed" (18MB/s for revision 5.3, 4.5 MB/s for revision 5.6). | |||
Standard UHS is not supported (card is working in the mode of "high speed"). | |||
== | ==Configuration== | ||
[[File:Hwconf microsd.jpg|thumb|300px| | [[File:Hwconf microsd.jpg|thumb|300px|Configuration]] | ||
Configuration is done in the web interface. Section Configs => Hardware Modules Configuration. | |||
Next, in Internal slot 3 select "WBE3-MICROSD: microSD module" and click Save. | |||
The device is detected immediately, no reboot is required. | |||
== | == Operation == | ||
The memory card is defined in the system as mmc1. The entire card is available as /dev/mmcblk1 is the card partitions as /dev/mmcblk1p0 etc. |